Author Topic: Ultrasonic  (Read 107 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2037
  • Karma: 199
  • Magnesium and Iron.
  • Location: Northern California.
Re: Ultrasonic
« Reply #10 on: February 12, 2017, 05:40:07 am »
That's the one I'd be leaning towards too.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

Offline jmester

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1853
  • Karma: 123
  • Location: MD
Re: Ultrasonic
« Reply #11 on: February 12, 2017, 07:28:37 am »
I still have not got one. Got side tracked the other day when I was looking at them. Got reading about what cleaning/chemicals people are using.
FEAR NO TREE. FEAR GOD.

Offline shoesnsocks

  • 3 cube
  • *
  • Posts: 13
  • Karma: 2
Re: Ultrasonic
« Reply #12 on: February 22, 2017, 10:59:32 am »
Since you guys are on the subject of Ultrasonic cleaners, what's a good temperature to run them at for a carburetor?

Online 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 3998
  • Karma: 220
  • Location: Carpenter, Wyoming
Re: Ultrasonic
« Reply #13 on: February 22, 2017, 06:30:41 pm »
Since you guys are on the subject of Ultrasonic cleaners, what's a good temperature to run them at for a carburetor?

Good question I have never used the heat.   I may pour some warm water in before using but that is about it.
PP 505, 475, 445.