« previous next »
Pages: 1 [2]   Go Down

Author Topic: Bar tip rivets  (Read 548 times)

0 Members and 46 Guests are viewing this topic.

Offline Philbert

  • Gas Hotsaw
  • ******
  • Posts: 563
  • Karma: 76

    • Total Badges: 23
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Level 5 Fifth year Anniversary 500 Posts Fourth year Anniversary
Re: Bar tip rivets
« Reply #10 on: February 16, 2014, 05:00:55 pm »
Here is the info for replacing the sprocket only, on conventional bars.

Philbert

Logged
Useful Useful x 1 View List

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

    • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Bar tip rivets
« Reply #11 on: February 17, 2014, 10:17:32 am »
I drill them and knock them out with a punch.   

To put them in I have a piece of railroad rail that I use for an anvil.   Then use a ball peen hammer.   
Logged
PP 505, 475, 445.
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
2 Replies
530 Views 		Last post January 12, 2012, 07:56:34 am
by farmboy
0 Replies
264 Views 		Last post February 02, 2014, 10:29:09 pm
by aclarke
3 Replies
285 Views 		Last post November 17, 2014, 01:17:43 pm
by 660magnum
6 Replies
715 Views 		Last post September 17, 2016, 07:16:52 pm
by Cut4fun .
1 Replies
281 Views 		Last post April 28, 2023, 11:03:45 am
by Cut4fun .