Author Topic: Chain grinders  (Read 269 times)

0 Members and 0 Guests are viewing this topic.

Offline Philbert

  • Gas Hotsaw
  • ******
  • Posts: 563
  • Karma: 75
Re: Chain grinders
« on: December 13, 2015, 11:47:19 pm »
I think that the motor is much smaller on the 410 grinder than the 520 grinder. It can be confusing, because sometimes there are errors in the printed specifications.

The 520 replaces the 511AX, which replaced the 511A.  IMO, the 511 series is the standard/reference grinder, against which other grinders are compared (e.g., 'it is smaller than the 511', or 'it is a clone/copy of a 511', etc.).  If you plan to use it on a regular basis, and keep it for a while, I would encourage you to look for one of those, or some close-out pricing on the 511AX grinders.  Chart of the current Oregon grinders attached.

Philbert

 

Related Topics

  Subject / Started by Replies Last post
195 Replies
9294 Views
Last post March 26, 2021, 01:52:18 pm
by 3000 FPS
2 Replies
430 Views
Last post February 10, 2013, 08:09:53 pm
by Al Smith
12 Replies
634 Views
Last post October 05, 2013, 09:25:13 am
by leec
26 Replies
919 Views
Last post February 03, 2014, 08:30:34 am
by SawTroll
15 Replies
387 Views
Last post December 12, 2013, 02:14:46 pm
by Gregsl
2 Replies
226 Views
Last post December 19, 2013, 11:47:37 pm
by RoyM
1 Replies
97 Views
Last post December 24, 2013, 11:36:57 pm
by Cut4fun .
2 Replies
309 Views
Last post May 03, 2014, 12:47:51 am
by 660magnum
20 Replies
482 Views
Last post December 20, 2014, 06:12:22 pm
by 660magnum
28 Replies
1020 Views
Last post December 14, 2015, 12:05:10 am
by Philbert