Author Topic: Fixable? Dealer says I'm screwed  (Read 1352 times)

0 Members and 45 Guests are viewing this topic.

Offline Philbert

  • Gas Hotsaw
  • ******
  • Posts: 563
  • Karma: 76

  • Total Badges: 23
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Level 5 Fifth year Anniversary 500 Posts Fourth year Anniversary
Nose Sprocket Repair - With Illustrations - 2
« on: May 01, 2014, 12:28:26 am »
2. I slid out the sprocket assembly on an old towel in case any of the tiny bearings tried to escape (26 in this Husky, 3/8" pitch, 5 rivet bar ; 15 in the Oregon, 3/8" low profile, single rivet bar!).

Sliding them out on thin cardstock (e.g. 3X5 card) helps to keep things together. You can see how the protective fibers from the chaps are wound right in with the bearings, and are not just between the sprocket and the inside of the guide bar.

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
1320 Views
Last post May 08, 2013, 08:51:22 pm
by Old Iron Logging
29 Replies
2330 Views
Last post February 02, 2016, 01:39:22 pm
by mowertech
24 Replies
976 Views
Last post September 19, 2014, 10:07:22 pm
by newowner?
11 Replies
887 Views
Last post September 11, 2014, 03:39:37 am
by pigpen60
6 Replies
1088 Views
Last post August 30, 2015, 10:50:09 pm
by RoyM
6 Replies
649 Views
Last post September 02, 2015, 02:23:36 pm
by Cut4fun .
0 Replies
610 Views
Last post February 04, 2017, 10:46:00 am
by mowertech
4 Replies
269 Views
Last post March 07, 2023, 10:04:49 am
by Cut4fun .