« previous next »
Pages: 1 2 [3] 4 5   Go Down

Author Topic: 3/8LP Picco rim sprocket  (Read 3114 times)

0 Members and 12 Guests are viewing this topic.

Offline srcarr52

  • 6 cube
  • ****
  • Posts: 288
  • Karma: 94
  • Location: IA

    • Total Badges: 22
    Badges: (View All)
    Third year Anniversary Level 5 Second year Anniversary 100 Posts Topic Starter Search
Re: Picco rim sprockets
« Reply #20 on: August 20, 2015, 10:52:09 am »
Quote from: SquareFile on August 20, 2015, 05:55:14 am
Tool post grinder on a lathe would work well. Carbide inserts don't like the case hardening of these "super hard" rims. Lol

I've cut down the OD of 8 pin .404 sprockets to make a lopro 8 pin standard spline before. Carbide doesn't like cutting them, but it will. I suppose shooting the holes for the splines was probably the worst on tooling.
Logged
Pages: 1 2 [3] 4 5   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
185 Replies
13048 Views 		Last post November 06, 2016, 12:22:58 pm
by HolmenTree
0 Replies
342 Views 		Last post July 28, 2011, 01:27:28 pm
by mweba
2 Replies
540 Views 		Last post September 29, 2011, 09:50:53 pm
by Cut4fun
11 Replies
2238 Views 		Last post July 13, 2015, 03:26:16 am
by fisaw
19 Replies
1235 Views 		Last post March 22, 2015, 07:54:43 pm
by jmester
5 Replies
927 Views 		Last post June 18, 2015, 12:34:28 pm
by Cut4fun .
5 Replies
739 Views 		Last post December 14, 2015, 04:59:13 am
by The Ripper
22 Replies
1189 Views 		Last post December 26, 2015, 09:04:59 pm
by jmester
8 Replies
553 Views 		Last post January 07, 2016, 08:08:04 pm
by 3000 FPS
2 Replies
340 Views 		Last post June 03, 2018, 05:29:02 pm
by Cut4fun .