Author Topic: Craftsman Chainsaw  (Read 2003 times)

0 Members and 9 Guests are viewing this topic.

Offline fordfairlane78

  • 6 cube
  • ****
  • Posts: 160
  • Karma: 16
  • Location: Valley Center,KS

  • Total Badges: 21
    Badges: (View All)
    Level 5 Poll Voter Second year Anniversary 100 Posts 50 Posts Level 4
Re: Craftsman Chainsaw
« on: April 02, 2014, 03:23:33 am »
It is best to use non ethanol fuel but very hard to find in bulk and the truefuel is expensive.  I run premium with Lucas synthetic mix @ 40:1 and I use Lucas ethanol treatment in all my small engine stuff. I typically take the low needle out about 3/4 turn and raise the idle  back up on the poulan products.  I usually don't have to mess with the high needle after this. I recently purchased 4 pp4218avx saws off of feebay as customer return items and each one has been the same adjustment.......
Trapped in time, surrounded by evil, low on gas

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
1703 Views
Last post July 18, 2012, 01:40:02 pm
by Cut4fun .
109 Replies
6345 Views
Last post March 19, 2024, 08:23:10 am
by Cut4fun
6 Replies
902 Views
Last post October 16, 2013, 03:40:39 pm
by KilliansRedLeo
3 Replies
568 Views
Last post November 13, 2013, 10:53:09 pm
by jcsmith
23 Replies
2613 Views
Last post November 16, 2021, 04:50:48 pm
by Cut4fun .
5 Replies
786 Views
Last post February 11, 2014, 03:36:38 pm
by Cut4fun
4 Replies
454 Views
Last post December 21, 2014, 08:08:43 pm
by AmericanPsycho
10 Replies
1294 Views
Last post April 27, 2016, 02:22:24 pm
by deezlfan
4 Replies
347 Views
Last post March 24, 2019, 08:21:08 pm
by Efisher26
1 Replies
351 Views
Last post March 26, 2019, 02:25:51 pm
by Efisher26