« previous next »
Pages: [1]   Go Down

Author Topic: green weedeater  (Read 171 times)

0 Members and 0 Guests are viewing this topic.

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 327
  • Karma: 28
green weedeater
« on: March 24, 2016, 04:53:08 pm »
started with 7 of these got 6 going . all i learned is when you think carburetor is clean and they don't run right clean it again. went to 50% purple power in ultrasonic cleaner. unlike mtd brand I did not run into internal engine problems. number 7 seems to be out of time but I got to work on saws now. 100% purple power eats on the aluminum.
Logged

Social Buttons

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 3933
  • Karma: 214
  • Location: Carpenter, Wyoming
Re: green weedeater
« Reply #1 on: March 24, 2016, 11:54:17 pm »
Even the 50% purple power will eat the aluminum if you leave it in there long enough.  I never use it for carbs.
Logged
PP 505, 475, 445.

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 327
  • Karma: 28
Re: green weedeater
« Reply #2 on: March 25, 2016, 11:29:02 am »
yes  you are correct don't leave them in it over an hour and rinse in water. put together get fuel mix in quick.  my whole idea was to speed up process . if you gonna put on shelf a while spray with wd40 or similar product, inside and outside.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
Poulan green paint

Started by Cut4fun « 1 2 3 4 5 » Poulan

47 Replies
2144 Views 		Last post October 29, 2016, 06:03:39 pm
by Sty57
25 Replies
4457 Views 		Last post December 20, 2011, 07:03:15 am
by Cut4fun .
3 Replies
375 Views 		Last post June 29, 2012, 12:09:17 pm
by SawTroll
2 Replies
609 Views 		Last post July 08, 2015, 05:02:35 pm
by Cut4fun .
7 Replies
654 Views 		Last post September 15, 2012, 09:57:41 am
by farmboy
33 Replies
515 Views 		Last post November 29, 2013, 09:53:20 pm
by 660magnum
7 Replies
412 Views 		Last post April 16, 2014, 03:04:06 pm
by KilliansRedLeo
13 Replies
463 Views 		Last post December 07, 2014, 05:51:30 pm
by Cut4fun .
1 Replies
50 Views 		Last post October 05, 2015, 12:51:52 pm
by Cut4fun .
4 Replies
190 Views 		Last post April 12, 2016, 06:30:34 pm
by dannyupsolate