« previous next »
Pages: [1]   Go Down

Author Topic: run a saw, as a engine, with no Bar and Chain attached.  (Read 550 times)

0 Members and 17 Guests are viewing this topic.

Offline RoyM

  • Gas Hotsaw
  • ******
  • Posts: 502
  • Karma: 45
  • Location: Surrey British Columbia

    • Total Badges: 21
    Badges: (View All)
    Level 5 500 Posts Fourth year Anniversary Third year Anniversary Karma Good Level 4
Re: run a saw, as a engine, with no Bar and Chain attached.
« on: April 24, 2015, 01:35:22 pm »
Go kart engines didn't have oil pumps, I would remove the pump and plug the tank outlet. As was mentioned, make darn sure the clutch is tight. I had one depart an XL-12, good thing no one was anywhere near me.
Logged
Old age and treachery always overcome youth and enthusiasm
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
3 Replies
573 Views 		Last post February 04, 2012, 10:28:30 am
by Cut4fun
8 Replies
548 Views 		Last post May 25, 2014, 12:26:46 pm
by SawDawg
7 Replies
980 Views 		Last post July 06, 2014, 02:51:54 pm
by 3000 FPS
1 Replies
332 Views 		Last post November 08, 2014, 09:17:54 am
by aclarke
12 Replies
933 Views 		Last post May 17, 2015, 12:57:39 am
by mcbob
19 Replies
759 Views 		Last post April 29, 2015, 03:46:30 pm
by Eccentric
9 Replies
1986 Views 		Last post May 07, 2020, 02:42:42 pm
by ray benson
4 Replies
671 Views 		Last post February 27, 2020, 02:59:14 am
by mkjt88
0 Replies
1020 Views 		Last post May 07, 2020, 09:32:22 am
by Cut4fun .
0 Replies
112 Views 		Last post August 20, 2023, 09:22:21 am
by Cut4fun .