Author Topic: craftsman poulan corded saw  (Read 333 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: craftsman poulan corded saw
« on: January 01, 2015, 04:01:48 pm »
That is actually Poulan made.  Don't know much about them, other than that they were well built (for a consumer electric saw).  A couple came into the shop when I was at Sears.  Cord replacements (due to abuse).  I like that they have two bar studs.  That one is late 1980's manufacture.  I've seen the same saws in Poulan green and Craftsman red.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
333 Views
Last post October 18, 2012, 04:02:23 pm
by Cut4fun .
104 Replies
2295 Views
Last post June 05, 2019, 10:51:03 am
by Cut4fun .
18 Replies
419 Views
Last post January 25, 2014, 08:03:36 am
by The Ripper
14 Replies
1055 Views
Last post November 01, 2015, 08:11:51 pm
by Philbert
13 Replies
395 Views
Last post March 26, 2017, 03:06:09 pm
by Revpop
9 Replies
189 Views
Last post February 04, 2015, 12:37:31 pm
by Cut4fun .
7 Replies
217 Views
Last post August 27, 2015, 10:13:48 am
by Cut4fun .
20 Replies
420 Views
Last post September 17, 2015, 07:59:02 am
by Chris-PA
12 Replies
352 Views
Last post February 18, 2016, 07:45:29 pm
by dannyupsolate
3 Replies
236 Views
Last post February 04, 2017, 10:34:46 am
by mowertech