« previous next »
Pages: [1] 2   Go Down

Author Topic: 5100S Problem  (Read 2082 times)

0 Members and 74 Guests are viewing this topic.

Offline wkpoor

  • 4 cube
  • **
  • Posts: 61
  • Karma: 2

    • Total Badges: 12
    Badges: (View All)
    Third year Anniversary Level 3 Karma Second year Anniversary Combination Topic Starter
Re: 5100S Problem
« on: May 01, 2012, 04:29:57 pm »
OK here is the deal. PTO bearing is spun. Did crank pressure and vac test. Won't make any vacuum and if you blow into the hose attached to the impulse port is free flows out the bearing seal. I'm curious to see how tight a new saw is and good running older one for comparison.
Logged
Pages: [1] 2   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
531 Views 		Last post May 08, 2011, 07:20:52 am
by peppone
3 Replies
849 Views 		Last post March 09, 2011, 07:47:49 pm
by hamish
2 Replies
1606 Views 		Last post December 10, 2011, 10:38:37 pm
by 660magnum
1 Replies
775 Views 		Last post January 19, 2012, 08:19:33 pm
by rgclmc
17 Replies
2571 Views 		Last post June 07, 2012, 07:26:43 am
by farmboy
4 Replies
3913 Views 		Last post February 20, 2013, 01:47:20 pm
by Cut4fun .
55 Replies
10928 Views 		Last post September 21, 2015, 07:42:19 pm
by mikehonda
22 Replies
1630 Views 		Last post August 29, 2013, 09:17:00 am
by fordfairlane78
3 Replies
473 Views 		Last post September 10, 2014, 09:13:00 pm
by pigpen60
5100s air leak

Started by dolmar « 1 2 3 » Dolmar Makita

21 Replies
1393 Views 		Last post January 16, 2015, 04:12:20 am
by dolmarfan