Author Topic: Dolmar 112  (Read 3182 times)

0 Members and 33 Guests are viewing this topic.

Offline OldJack

  • 3 cube
  • *
  • Posts: 11
  • Karma: 2
  • Location: Saskatchewan

  • Total Badges: 13
    Badges: (View All)
    Level 3 10 Posts Fourth year Anniversary Third year Anniversary Karma Second year Anniversary
Re: Dolmar 112
« Reply #30 on: April 16, 2015, 02:56:58 am »
A point to consider, if you'll pardon the pun. I'm rusty on my points and condenser theory, but the points should open at the time of minimum current flow across them to prevent arcing and burning. Running with the wrong point gap isn't good for the points. The condenser controls the current flow across the points and a bad condenser will eat points.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Dolmar 112
« Reply #31 on: April 16, 2015, 10:41:34 am »
I believe the condenser will discharge the voltage to ground instead of arching across the contacts of the points.   
That is the nature of capacitance.
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
1120 Views
Last post March 24, 2012, 11:18:52 am
by farmboy
9 Replies
669 Views
Last post December 19, 2013, 08:36:56 pm
by fastleo151
13 Replies
1379 Views
Last post January 11, 2014, 06:09:41 pm
by Bitburger
73 Replies
2790 Views
Last post July 03, 2014, 12:15:14 pm
by Cut4fun .
Dolmar parts

Started by aclarke « 1 2 » Dolmar Makita

11 Replies
1509 Views
Last post April 23, 2014, 11:50:04 am
by KilliansRedLeo
8 Replies
893 Views
Last post August 26, 2014, 12:14:10 am
by stihls066
8 Replies
1487 Views
Last post May 24, 2014, 12:12:54 am
by dutchsawdoctor
0 Replies
225 Views
Last post April 12, 2014, 12:28:35 am
by stihls066
3 Replies
593 Views
Last post April 21, 2014, 09:22:19 pm
by 3000 FPS
3 Replies
288 Views
Last post April 22, 2023, 10:56:40 am
by Cut4fun .