Author Topic: Dolmar 5000  (Read 8018 times)

0 Members and 35 Guests are viewing this topic.

Offline Magnus

  • 6 cube
  • ****
  • Posts: 237
  • Karma: 26
  • Location: Sweden
    • Chainsaw Collectors Forum

  • Total Badges: 23
    Badges: (View All)
    Linux User Third year Anniversary Level 5 Signature Avatar Mobile User
Re: Dolmar 5000
« Reply #70 on: November 11, 2012, 03:46:11 am »
What is the L needle setting? Is that two turns (or more) out as well? Is Idle strong and steady? Change in rpm as it change position? Hesitate on acceleration? Run strong in wood?

The 13 500rpms was without load and bar/chain mounted?
It is not that uncommon rpm as it hits limiter and can't go higher.

Pressure test is a good start. Test carb as well when you have the stuff out. Set carb under pressure so you see when needle open.
By adjusting the lever under pressure it gives more accurate amount of fuel.
Chainsaw nut!

 

Related Topics

  Subject / Started by Replies Last post
5000 plus

Started by CGK-60 Partner

2 Replies
752 Views
Last post November 18, 2011, 08:00:01 pm
by CGK-60
7 Replies
1596 Views
Last post January 05, 2012, 06:38:47 am
by Al Smith
10 Replies
1878 Views
Last post August 27, 2012, 01:13:55 pm
by CASE5854x4
echo 5000

Started by Cut4fun . « 1 2 ... 5 6 » Echo

52 Replies
3899 Views
Last post January 01, 2016, 08:15:42 am
by old 040
0 Replies
928 Views
Last post February 09, 2013, 11:40:42 am
by Cut4fun .
9 Replies
667 Views
Last post December 19, 2013, 08:36:56 pm
by fastleo151
Dolmar parts

Started by aclarke « 1 2 » Dolmar Makita

11 Replies
1509 Views
Last post April 23, 2014, 11:50:04 am
by KilliansRedLeo
500/5000 gaskets

Started by aclarke « 1 2 » Partner

11 Replies
1234 Views
Last post November 02, 2015, 08:02:13 am
by Cut4fun .
11 Replies
1378 Views
Last post January 20, 2016, 03:32:33 pm
by jeff.lary
2 Replies
239 Views
Last post April 01, 2023, 09:46:59 am
by Cut4fun