Chainsaw Repair

Do you have an ultrasound cleaner? I would highly recomend one of those for your carb. I have one of the jewlery very small models without heat. They would be absolutely sufficient if you don't need it often. It still works great. My procedure is dismantle the carb and place it into the us cleaner and add:
1. hot faucet water with simple green and run it max time
2. new! hot faucet water with simple green and run it max time
3. new! hot faucet water with simple green and run it max time
4. new! hot faucet water without anything!!! and run it max time, this is to remove any "soap" residues
5. blow dry carefully with the compressor, spray through all the holes with wd40, reassemble, run saw

!!!!What is important when exchanging the water => dumping the old water/dirt mix into the sink, is to dump it through a strainer/filter/sieve whatever! Because small parts like going down the drain too... Don't ask how I know!

Good luck!

7