Author Topic: Dolmar 7300  (Read 152 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4106
  • Karma: 166
  • OHIO REDNECK
Re: Dolmar 7300
« on: April 09, 2020, 08:07:32 am »
Saving info. Fly side crank.  He said he cut  m8x1.25 threads before reinstalling  and then shearing key.
 I think it was more of both surfaces wasnt cleaned good and fly not tightened good. Just my WAG

He also had used red loctite. Thanks goodness it didnt hold on nut.

Pic of threads before die used. They looked good when I seen them now. But was leery to tighten down like I normally do.





REDNECK Saw Repair

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
1174 Views
Last post March 10, 2012, 07:00:24 am
by MCW
0 Replies
428 Views
Last post February 04, 2013, 08:22:02 am
by Cut4fun
3 Replies
259 Views
Last post April 13, 2013, 02:21:07 pm
by 660magnum
17 Replies
572 Views
Last post January 26, 2014, 09:59:09 am
by Cut4fun .
6 Replies
933 Views
Last post June 30, 2017, 05:39:15 pm
by Philbert
31 Replies
779 Views
Last post March 04, 2014, 05:20:16 pm
by 660magnum
26 Replies
580 Views
Last post April 02, 2014, 09:03:00 pm
by Cut4fun .
59 Replies
517 Views
Last post December 03, 2014, 07:51:38 pm
by 660magnum
3 Replies
430 Views
Last post January 03, 2016, 03:19:17 pm
by Eccentric
0 Replies
381 Views
Last post May 25, 2018, 09:23:42 am
by Cut4fun .