« previous next »
Pages: [1] 2 3   Go Down

Author Topic: Factory Tools?  (Read 2012 times)

0 Members and 77 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO

    • Total Badges: 39
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary 5000 Posts Third year Anniversary
Re: Factory Tools?
« on: May 29, 2014, 09:57:13 pm »
Also in 2009 there was a new chain catcher used that is rounded on the chain side.

There was also a cup added to the upper AV on the top handle to cylinder as a travel limiter.

If the rubber tail (166 chip guide, part # 038 213 190) is not on the back of the chain cover, chips will eventually erode the front corner of the gas tank.
Logged
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .
Pages: [1] 2 3   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
1 Replies
719 Views 		Last post October 02, 2011, 01:28:03 pm
by Sven Johnson
37 Replies
6345 Views 		Last post February 21, 2014, 03:18:14 am
by fordfairlane78
1 Replies
422 Views 		Last post October 19, 2013, 11:59:12 pm
by stihls066
17 Replies
1520 Views 		Last post December 02, 2013, 03:51:23 pm
by jmester
38 Replies
2739 Views 		Last post December 07, 2018, 02:46:41 pm
by Philbert
31 Replies
1407 Views 		Last post November 25, 2015, 10:07:18 am
by Cut4fun .
2 Replies
607 Views 		Last post November 05, 2016, 01:21:29 pm
by fisaw
2 Replies
445 Views 		Last post August 19, 2017, 11:55:21 am
by deezlfan
4 Replies
1064 Views 		Last post November 04, 2017, 11:29:52 pm
by mdavlee .
0 Replies
318 Views 		Last post June 11, 2018, 11:27:52 am
by Cut4fun .