Author Topic: help: flushing oil tank  (Read 904 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22121
  • Karma: 551
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: help: flushing oil tank
« on: December 11, 2011, 06:54:24 pm »
I have used kerosene and I have had better luck just using old mix to flush with. 

Then after flushing fill the oil tank up with mix and I actually start the saw with NO bar and chain on it and run it through the whole oiler system till I see it flowing like it suppose too.  Never ran into any problems this  way yet.

Anyone see anything wrong with this?  It's been working for me.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
6 Replies
307 Views
Last post October 04, 2012, 01:26:19 pm
by Cut4fun
11 Replies
507 Views
Last post November 01, 2012, 03:09:39 pm
by Cut4fun
6 Replies
503 Views
Last post December 17, 2012, 05:29:48 pm
by Al Smith
7 Replies
2251 Views
Last post April 23, 2013, 04:21:14 pm
by Go JayBee
1 Replies
183 Views
Last post June 26, 2013, 08:07:52 pm
by Cut4fun .
0 Replies
130 Views
Last post September 26, 2013, 10:14:34 am
by KilliansRedLeo
40 Replies
697 Views
Last post January 30, 2014, 10:44:24 am
by 660magnum
13 Replies
320 Views
Last post October 05, 2014, 11:23:57 pm
by 3000 FPS
16 Replies
1093 Views
Last post April 11, 2014, 07:03:51 am
by Tractorsaw1
2 Replies
157 Views
Last post February 25, 2014, 08:19:35 pm
by Eccentric