Author Topic: Maktia Dolmar 8100  (Read 687 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Maktia Dolmar 8100
« Reply #10 on: July 30, 2016, 06:13:13 pm »
That's a good question Mike.  Husky has been taking forever and a day with that one.  They've had saws out for testing for so long that they've probably had to start over with the next generation of AT hardware/software (maybe more than once). 
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

Offline mdavlee .

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1968
  • Karma: 171
Re: Maktia Dolmar 8100
« Reply #11 on: July 30, 2016, 06:26:49 pm »
True. 2011 was the first I heard about it.

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
709 Views
Last post March 24, 2012, 11:18:52 am
by farmboy
12 Replies
1043 Views
Last post October 14, 2012, 06:43:27 am
by man of stihl
2 Replies
1006 Views
Last post July 24, 2012, 02:02:06 pm
by Cut4fun
6 Replies
1288 Views
Last post October 25, 2015, 09:31:29 pm
by mikehonda
22 Replies
868 Views
Last post September 05, 2013, 10:23:36 pm
by KilliansRedLeo
Dolmar 112

Started by 3000 FPS « 1 2 3 4 » Dolmar Makita

31 Replies
1304 Views
Last post April 16, 2015, 10:41:34 am
by 3000 FPS
3 Replies
433 Views
Last post June 19, 2014, 04:40:38 pm
by dutchsawdoctor
1 Replies
136 Views
Last post September 10, 2014, 01:29:01 pm
by aclarke
3 Replies
172 Views
Last post January 13, 2015, 12:03:22 am
by dannyupsolate
8 Replies
495 Views
Last post April 12, 2016, 06:56:28 pm
by Cut4fun .