« previous next »
Pages: 1 2 3 4 [5] 6   Go Down

Author Topic: My 7300 went kapoot!  (Read 1692 times)

0 Members and 25 Guests are viewing this topic.

Offline Ducksnuff870

  • 6 cube
  • ****
  • Posts: 174
  • Karma: 16

    • Total Badges: 22
    Badges: (View All)
    Combination Level 5 Level 4 100 Posts Avatar Third year Anniversary
Re: My 7300 went kapoot!
« Reply #40 on: December 03, 2014, 05:31:27 pm »

Quote from: 660magnum on December 03, 2014, 05:15:58 pm
It was run too lean one way or the other?

You need an opinion from Kevin if he thinks the cylinder will clean up?

If so, all you'll need is a Piston/ring and a base gasket?

There's probably a vacuum leak or the 7300 wouldn't have been lean?

Yea was wondering what to start addressing. Definitely leaned out for reason unknown to me. Prob wouldn 't hurt to have kevin look at it. No point in installing new p/c if its gonna do it again.
Logged
Pages: 1 2 3 4 [5] 6   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
1 Replies
1511 Views 		Last post March 10, 2012, 07:00:24 am
by MCW
0 Replies
630 Views 		Last post February 04, 2013, 08:22:02 am
by Cut4fun
3 Replies
615 Views 		Last post April 13, 2013, 02:21:07 pm
by 660magnum
17 Replies
1468 Views 		Last post January 26, 2014, 09:59:09 am
by Cut4fun .
6 Replies
1776 Views 		Last post June 30, 2017, 05:39:15 pm
by Philbert
7 Replies
614 Views 		Last post February 05, 2014, 09:06:04 pm
by KilliansRedLeo
31 Replies
2086 Views 		Last post March 04, 2014, 05:20:16 pm
by 660magnum
26 Replies
1464 Views 		Last post April 02, 2014, 09:03:00 pm
by Cut4fun .
3 Replies
819 Views 		Last post January 03, 2016, 03:19:17 pm
by Eccentric
9 Replies
1187 Views 		Last post February 27, 2021, 09:40:58 am
by Al Smith