Author Topic: replace flywheel on Makita DCS6421  (Read 407 times)

0 Members and 0 Guests are viewing this topic.

Online jmester

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2065
  • Karma: 158
  • Location: MD
Re: replace flywheel on Makita DCS6421
« on: July 17, 2016, 09:04:44 pm »
It should be a taper fit. I use a rubber mallet to help seat the flywheel. Make sure you support the crankshaft on the pto to help prevent any side to side movement. Make sure that you torque the nut. Not sure what dolmar has for the torque spec but most stihls that size are around 25 ft lbs or 33nm. Hope this helps you as flywheels are expensive.
FEAR NO TREE. FEAR GOD.

 

Related Topics

  Subject / Started by Replies Last post
Makita 540 ?

Started by Al Smith « 1 2 3 4 » Dolmar Makita

32 Replies
1368 Views
Last post October 05, 2012, 07:37:14 am
by pete
2 Replies
722 Views
Last post November 06, 2013, 07:57:16 pm
by 3000 FPS
8 Replies
387 Views
Last post March 12, 2014, 09:42:07 am
by KilliansRedLeo
20 Replies
1119 Views
Last post July 25, 2014, 07:54:45 pm
by fuzz1500
makita 6401

Started by pigpen60 « 1 2 » Dolmar Makita

16 Replies
485 Views
Last post November 01, 2014, 02:57:00 am
by pete
makita 6421

Started by pigpen60 « 1 2 » Dolmar Makita

15 Replies
414 Views
Last post September 11, 2014, 08:47:10 pm
by pigpen60
10 Replies
346 Views
Last post April 16, 2015, 08:12:11 pm
by SawTroll
1 Replies
285 Views
Last post March 06, 2016, 05:57:13 pm
by Cut4fun .
4 Replies
153 Views
Last post February 27, 2017, 05:53:53 am
by dmccann
3 Replies
148 Views
Last post February 08, 2018, 08:50:19 pm
by mdavlee .