Author Topic: Stripped bar bolt PS540  (Read 180 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22074
  • Karma: 548
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Stripped bar bolt PS540
« on: February 06, 2019, 08:25:07 am »
Nate a dolmar makita echo dealer  =  i would skip the helicoil....key sert like shawn suggested or time sert. on holes that were to big for a time sert i have also drilled/tapped to next size up and screwed a bolt in it with red loctite on it. after it set up i cut the bolt off flush and drilled/tapped it for the correct thread.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
22 Replies
2668 Views
Last post September 20, 2014, 06:12:53 pm
by aclarke
9 Replies
497 Views
Last post December 03, 2013, 10:21:18 am
by Cut4fun .
31 Replies
796 Views
Last post November 17, 2013, 05:05:45 pm
by oldtimber
4 Replies
667 Views
Last post November 28, 2013, 08:16:36 pm
by Jd2007
7 Replies
355 Views
Last post February 17, 2015, 09:13:42 pm
by mcbob
8 Replies
151 Views
Last post December 28, 2014, 11:58:30 am
by srcarr52
1 Replies
220 Views
Last post January 25, 2016, 11:21:00 am
by srcarr52
1 Replies
159 Views
Last post February 12, 2016, 09:13:00 am
by fuzz1500
2 Replies
479 Views
Last post September 05, 2016, 04:36:35 pm
by Giles
1 Replies
148 Views
Last post May 19, 2019, 07:45:02 am
by Cut4fun .