Author Topic: 306 top handle  (Read 119 times)

0 Members and 0 Guests are viewing this topic.

Offline leec

  • 6 cube
  • ****
  • Posts: 264
  • Karma: 14
  • Location: Huntsville, Ontario
306 top handle
« on: July 12, 2017, 02:52:49 pm »
This is the one with the new piston.  Starts easily revs up but dies in the cut after 2-3 seconds.  Then starts up just fine.  Can't seem to get the H & L right.

Share on Facebook Share on Twitter


Offline mountainlake

  • 5 cube
  • ***
  • Posts: 119
  • Karma: 21
Re: 306 top handle
« Reply #1 on: July 14, 2017, 06:03:25 am »
 
 Check the metering valve height real close, If my saw I'd just bend it up a bit so it opens the needle a little more and give it a try.  Steve

Offline leec

  • 6 cube
  • ****
  • Posts: 264
  • Karma: 14
  • Location: Huntsville, Ontario
Re: 306 top handle
« Reply #2 on: July 19, 2017, 03:36:31 pm »
Thanks ,  I'll give it a try.

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
196 Views
Last post February 19, 2013, 08:07:04 pm
by riverrocket
Vintage top handle

Started by brettl « 1 2 » Stihl

10 Replies
209 Views
Last post February 22, 2014, 03:14:50 pm
by Fish
3 Replies
165 Views
Last post May 12, 2014, 03:36:02 pm
by winland
14 Replies
269 Views
Last post September 29, 2014, 08:37:41 pm
by Al Smith
2 Replies
745 Views
Last post January 25, 2015, 10:19:07 am
by 67L36Driver
6 Replies
165 Views
Last post July 18, 2017, 02:25:37 am
by 3000 FPS
6 Replies
395 Views
Last post April 08, 2016, 08:41:29 pm
by Nathaniel Vansickle
0 Replies
121 Views
Last post October 23, 2016, 12:19:01 pm
by Cut4fun
2 Replies
107 Views
Last post July 03, 2019, 01:23:14 pm
by Cut4fun .
4 Replies
76 Views
Last post May 01, 2020, 03:18:04 pm
by Cut4fun .