« previous next »
Pages: 1 2 3 4 [5] 6 7 8   Go Down

Author Topic: Echo 8000  (Read 7893 times)

0 Members and 93 Guests are viewing this topic.

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4672
  • Karma: 216
  • OHIO REDNECK

    • Total Badges: 44
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 7 Seventh year Anniversary Apple User
Re: 8000 echo
« Reply #40 on: November 21, 2011, 02:41:51 pm »
Quote from: sharkey on November 21, 2011, 12:17:04 am
Installed an 8000 p&c set last week which came from the factory with a pop up and quad port cylinder.  The old flat top p&c ran a loose squish.  The new set after installation is around 180psi stock with about 15 minutes run time.  OEM Part number for the p&c set is p050005320.  This is rings, piston, clips, pin, base gasket, and top bearing.     

Do you happen to have any pictures you could post? Sounds real gooooooood.

Logged
Pages: 1 2 3 4 [5] 6 7 8   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
13 Replies
2713 Views 		Last post December 07, 2011, 05:32:23 pm
by brokenbudget
9 Replies
1548 Views 		Last post September 02, 2013, 06:30:22 pm
by Cut4fun .
5 Replies
1218 Views 		Last post March 10, 2014, 09:48:26 pm
by 3000 FPS
Echo CS-8000

Started by KilliansRedLeo « 1 2 » Echo

10 Replies
1265 Views 		Last post March 15, 2014, 02:03:04 pm
by Cut4fun .
11 Replies
1448 Views 		Last post August 13, 2015, 12:39:22 pm
by HolmenTree
5 Replies
1346 Views 		Last post December 24, 2015, 11:45:00 am
by Cut4fun .
1 Replies
536 Views 		Last post December 23, 2015, 09:16:24 pm
by Cut4fun .
3 Replies
325 Views 		Last post February 17, 2016, 04:10:32 am
by dutchsawdoctor
0 Replies
426 Views 		Last post June 15, 2016, 08:20:51 pm
by Cut4fun .
1 Replies
263 Views 		Last post July 12, 2020, 11:16:02 am
by Cut4fun .