« previous next »
Pages: [1]   Go Down

Author Topic: CS-400 piston  (Read 804 times)

0 Members and 58 Guests are viewing this topic.

Offline brettl

  • 6 cube
  • ****
  • Posts: 179
  • Karma: 7

    • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Second year Anniversary Level 4 One year Anniversary Linux User Mobile User
Re: CS-400 piston
« on: January 07, 2017, 10:33:02 pm »
I was afraid of that. Its a little surprising, considering the popularity of the saw and all the problems folks have getting them lean from the dealer. So far, I've only found the piston kit (wrist pin, clips, etc) on eBay for $55. Hate to put that much in just a piston. I'm going to tear it down and make sure of the cylinder and bottom end before I buy a piston.
Logged
Sthil Man. 011AV, 015, 020, 020, 024, 025, 026, 028 WB(2), 028AV, 028 Super, 029 Super(2), 039, 041, 192TC, 200T, 250, 260, 390, 440, 441
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
11 Replies
1310 Views 		Last post March 07, 2011, 02:39:37 pm
by Old Iron Logging
15 Replies
934 Views 		Last post December 17, 2012, 12:02:09 pm
by Remington
8 Replies
722 Views 		Last post January 23, 2015, 05:25:39 pm
by Cut4fun .
9 Replies
560 Views 		Last post March 04, 2015, 03:15:47 pm
by GCC
Top of piston has....

Started by SDB777 « 1 2 3 » Stihl

21 Replies
1316 Views 		Last post September 25, 2015, 02:29:31 pm
by Cut4fun .
4 Replies
585 Views 		Last post December 15, 2015, 10:18:08 am
by dannyupsolate
12 Replies
861 Views 		Last post May 23, 2017, 01:51:26 pm
by Cut4fun .
Harvest piston

Started by dpjones « 1 2 » Stihl

10 Replies
471 Views 		Last post June 21, 2017, 06:14:43 pm
by sharkey
7 Replies
675 Views 		Last post September 17, 2017, 08:36:07 am
by Fishnuts2
4 Replies
59 Views 		Last post March 05, 2024, 03:28:35 pm
by Simas Alijo?ius