Author Topic: CS-590 throwing alot of oil but not on the chain and bar  (Read 1607 times)

0 Members and 0 Guests are viewing this topic.

Offline echoer

  • 3 cube
  • *
  • Posts: 10
  • Karma: 1
sweepleader
I have let the saw sit and it doesnt leak by itself. I did clean it and took the bar off and ran it and it seems it is coming out only from the port but once the channels are full the oil never makes it in the bar.

cut4fun
There seems to be a little oil in there but most of it is in the housing and dripping down. It doesnt come out of the tip like my other echo-490 and makes a like line.
Seems the bar doesnt have a hole at the bottom and that causes all the oil to run in the housing.

 

Related Topics

  Subject / Started by Replies Last post
7 Replies
1112 Views
Last post February 19, 2012, 08:25:44 pm
by Cut4fun .
5 Replies
554 Views
Last post January 31, 2012, 10:10:59 pm
by Al Smith
3 Replies
441 Views
Last post December 11, 2018, 04:09:16 pm
by fisaw
31 Replies
894 Views
Last post October 23, 2016, 08:35:47 pm
by Eccentric
12 Replies
567 Views
Last post October 05, 2013, 09:25:13 am
by leec
26 Replies
821 Views
Last post February 03, 2014, 08:30:34 am
by SawTroll
15 Replies
374 Views
Last post December 12, 2013, 02:14:46 pm
by Gregsl
2 Replies
189 Views
Last post December 19, 2013, 11:47:37 pm
by RoyM
1 Replies
92 Views
Last post December 24, 2013, 11:36:57 pm
by Cut4fun .
1 Replies
229 Views
Last post April 17, 2014, 12:08:43 pm
by 660magnum