« previous next »
Pages: [1]   Go Down

Author Topic: cs3400 carb adjustment whoes  (Read 833 times)

0 Members and 0 Guests are viewing this topic.

Offline fordfairlane78

  • 6 cube
  • ****
  • Posts: 160
  • Karma: 16
  • Location: Valley Center,KS
cs3400 carb adjustment whoes
« on: April 11, 2012, 11:56:48 pm »
Just purchased a non-running cs3400 with carb problems. Cleaned out the carb&replaced the diaphragm. It runs but the carb has the stupid plastic h/l needle adjustments that are stopping me from making it run correctly. Is this the correct carb as I haven't ran the #'sI yet? If it is right how do I get around these? If its not what other carbs are compatible as I have a plethora of parts saws available.  Thanks for any help....
Logged
Trapped in time, surrounded by evil, low on gas

Share on Facebook Share on Twitter

Offline fordfairlane78

  • 6 cube
  • ****
  • Posts: 160
  • Karma: 16
  • Location: Valley Center,KS
Re: cs3400 carb adjustment whoes
« Reply #1 on: April 16, 2012, 04:52:37 am »
Figured it out....just broke out the plastic pieces to reveal normal needle screws..Removed the excess of the carb housing around these plastic stops with a cutoff wheel, added tension springs to the needles &adjusted it out. Runs great!
Logged
Trapped in time, surrounded by evil, low on gas
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
1 Replies
3318 Views 		Last post July 04, 2012, 07:01:38 pm
by Al Smith
10 Replies
1753 Views 		Last post January 24, 2013, 05:24:54 am
by Al Smith
Carb adjustment

Started by riverrocket « 1 2 » Stihl

11 Replies
1713 Views 		Last post March 03, 2013, 11:38:25 am
by jmester
5 Replies
2474 Views 		Last post December 02, 2013, 12:43:01 pm
by UNCLEBEEF
1 Replies
483 Views 		Last post February 06, 2014, 08:52:17 pm
by KilliansRedLeo
4 Replies
12534 Views 		Last post December 08, 2022, 09:46:09 am
by Cut4fun .
7 Replies
1049 Views 		Last post May 01, 2015, 02:05:03 pm
by 660magnum
7 Replies
2481 Views 		Last post January 31, 2018, 03:02:37 pm
by Cut4fun .
1 Replies
824 Views 		Last post April 04, 2019, 06:43:25 pm
by Cut4fun .
3 Replies
5444 Views 		Last post April 23, 2020, 07:30:02 am
by Cut4fun .