Author Topic: CS500VL w/electronic module  (Read 127 times)

0 Members and 0 Guests are viewing this topic.

Offline copen

  • pruner
  • *
  • Posts: 2
  • Karma: 0
CS500VL w/electronic module
« on: December 02, 2017, 11:36:12 am »
Since points and condensers weren't available for my saw I installed one of these modules. Had been running fine for years but for some reason it will no longer idle. Anyone heard of a EM causing this? Doesn't make sense to me but I've had the carb apart several times, cleaning it with 2+2 gum cutter and blowing it out, soaked it in hot water, very hot, blew it out, and pulled the fuel filter out of the tank to make sure there were no problems there. It does run on part throttle and goes like Hello on full throttle. All gaskets and seals look good. Wish I had another carb to try, but I don't. Any suggestions?
Thanks in advance for any help, Bill

Share on Facebook Share on Twitter


 

Related Topics

  Subject / Started by Replies Last post
4 Replies
547 Views
Last post April 30, 2011, 05:18:30 pm
by mcbob
19 Replies
2644 Views
Last post January 31, 2012, 09:09:32 pm
by Al Smith
3 Replies
374 Views
Last post July 29, 2013, 06:15:02 pm
by sharkey
3 Replies
911 Views
Last post December 13, 2013, 05:00:34 pm
by brokenbudget
1 Replies
431 Views
Last post January 07, 2014, 11:28:23 pm
by jmester
0 Replies
2537 Views
Last post August 10, 2014, 09:06:55 pm
by foggysail
8 Replies
140 Views
Last post April 29, 2015, 11:48:00 am
by 3000 FPS
2 Replies
112 Views
Last post July 11, 2015, 07:07:14 am
by jmester
7 Replies
290 Views
Last post January 05, 2019, 05:07:42 pm
by trappermike
0 Replies
95 Views
Last post October 29, 2017, 10:04:50 pm
by Jaymo