« previous next »
Pages: [1]   Go Down

Author Topic: Echo cs301, 346, 306 saws  (Read 288 times)

0 Members and 0 Guests are viewing this topic.

Offline leec

  • 6 cube
  • ****
  • Posts: 264
  • Karma: 14
  • Location: Huntsville, Ontario
Echo cs301, 346, 306 saws
« on: January 13, 2017, 08:49:00 pm »
Couls I get an initial H & L carb setting for these saws.  manual only refers to carbs with limiters no inintial settings, ie 1 1/2 out for L and 1 out for high.  I know some of the newer saws are a lot further out.  Thanks
Logged

Share on Facebook Share on Twitter

Offline leec

  • 6 cube
  • ****
  • Posts: 264
  • Karma: 14
  • Location: Huntsville, Ontario
Re: Echo cs301, 346, 306 saws
« Reply #1 on: January 16, 2017, 09:52:03 pm »
OK guys I discouvered it myself, about 1 3/4 on L and 1 on H.  I'll run it a bit rich as it has a new piston with caber ring.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
3 Replies
630 Views 		Last post September 26, 2011, 09:53:17 pm
by Cut4fun .
26 Replies
2156 Views 		Last post September 13, 2012, 11:12:37 am
by SawTroll
8 Replies
747 Views 		Last post September 28, 2013, 03:47:02 pm
by Cut4fun .
5 Replies
595 Views 		Last post January 27, 2016, 09:04:28 pm
by 3000 FPS
3 Replies
1008 Views 		Last post July 13, 2015, 12:44:12 am
by Eccentric
23 Replies
3787 Views 		Last post December 18, 2014, 01:38:25 pm
by Cut4fun .
22 Replies
3028 Views 		Last post September 04, 2016, 09:28:57 pm
by hseII
8 Replies
497 Views 		Last post May 21, 2015, 12:44:22 pm
by Nathaniel Vansickle
0 Replies
351 Views 		Last post October 17, 2019, 10:46:17 am
by Cut4fun .
0 Replies
260 Views 		Last post June 20, 2021, 09:22:00 am
by Cut4fun