Author Topic: Echo CS440  (Read 1642 times)

0 Members and 15 Guests are viewing this topic.

Offline sharkey

  • Piped Saw
  • *****
  • Posts: 368
  • Karma: 37

  • Total Badges: 26
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Level 5
Re: Echo CS440
« on: November 19, 2013, 06:56:51 am »
If you take a close look at the side of the carb, you will see two notches that are present on the outer plate that holds the red caps to the carb.  Use a piece of wire or a magnifying glass and turn the cap to the left until the red stop shows through the notch.  Insert a drywall screw into the center of the red cap and turn it in clockwise.  The cap will slide right out.  Once you get them both out, use a drywall cutter or knife to cut the tabs off the side of the caps.  This will make the needles fully adjustable but you will retain the caps to protect from vibration.   

 

Related Topics

  Subject / Started by Replies Last post
Echo 280

Started by Cut4fun . « 1 2 » Echo

10 Replies
2045 Views
Last post May 21, 2013, 03:48:18 pm
by Cut4fun .
2 Replies
1009 Views
Last post February 06, 2012, 08:39:26 pm
by DB_43725
Echo 702

Started by Cut4fun . « 1 2 3 4 » Echo

32 Replies
4108 Views
Last post March 10, 2016, 03:44:56 pm
by Cut4fun .
Echo 452

Started by Cut4fun Echo

2 Replies
1208 Views
Last post April 23, 2012, 11:19:35 pm
by DB_43725
Echo CS 60S

Started by Dh1984 Echo

4 Replies
1506 Views
Last post June 05, 2012, 06:33:11 pm
by Dh1984
1 Replies
695 Views
Last post October 27, 2012, 10:27:31 pm
by Al Smith
Echo CS330t

Started by Giles Echo

2 Replies
508 Views
Last post January 04, 2013, 11:47:57 am
by Remington
6 Replies
555 Views
Last post March 21, 2013, 03:31:55 pm
by Dh1984
7 Replies
592 Views
Last post July 04, 2013, 09:17:16 am
by Cut4fun .
Echo 290

Started by Cut4fun . Echo

1 Replies
680 Views
Last post September 19, 2013, 05:24:50 pm
by sharkey