Author Topic: CS500VL w/electronic module  (Read 148 times)

0 Members and 0 Guests are viewing this topic.

Offline copen

  • pruner
  • *
  • Posts: 2
  • Karma: 0
CS500VL w/electronic module
« on: December 02, 2017, 11:36:12 am »
Since points and condensers weren't available for my saw I installed one of these modules. Had been running fine for years but for some reason it will no longer idle. Anyone heard of a EM causing this? Doesn't make sense to me but I've had the carb apart several times, cleaning it with 2+2 gum cutter and blowing it out, soaked it in hot water, very hot, blew it out, and pulled the fuel filter out of the tank to make sure there were no problems there. It does run on part throttle and goes like Hello on full throttle. All gaskets and seals look good. Wish I had another carb to try, but I don't. Any suggestions?
Thanks in advance for any help, Bill

Share on Facebook Share on Twitter


 

Related Topics

  Subject / Started by Replies Last post
4 Replies
182 Views
Last post June 02, 2011, 06:46:09 pm
by Al Smith
4 Replies
549 Views
Last post April 30, 2011, 05:18:30 pm
by mcbob
3 Replies
394 Views
Last post July 29, 2013, 06:15:02 pm
by sharkey
1 Replies
63 Views
Last post June 02, 2014, 11:08:00 am
by mowertech
1 Replies
451 Views
Last post January 07, 2014, 11:28:23 pm
by jmester
0 Replies
2829 Views
Last post August 10, 2014, 09:06:55 pm
by foggysail
2 Replies
114 Views
Last post July 11, 2015, 07:07:14 am
by jmester
3 Replies
50 Views
Last post November 23, 2016, 11:09:13 pm
by oldpro
7 Replies
319 Views
Last post January 05, 2019, 05:07:42 pm
by trappermike
0 Replies
101 Views
Last post October 29, 2017, 10:04:50 pm
by Jaymo