« previous next »
Pages: [1]   Go Down

Author Topic: Nut/Bolt Torque  (Read 469 times)

0 Members and 0 Guests are viewing this topic.

Offline Giles

  • 6 cube
  • ****
  • Posts: 157
  • Karma: 12
  • Location: Florence Alabama
Nut/Bolt Torque
« on: September 05, 2016, 03:54:38 pm »
There is only one item on a chainsaw that I consider needing to be torqued.
That is the flywheel nut.
Can anyone tell me what torque is needed for the flywheel nut  on a red Echo CS330t?
Logged

Share on Facebook Share on Twitter

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21945
  • Karma: 532
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Nut/Bolt Torque
« Reply #1 on: September 05, 2016, 04:23:43 pm »
I just snug them down.  Never checked any with a torque wrench.
Logged
REDNECK Saw Repair Getter Done

Offline Giles

  • 6 cube
  • ****
  • Posts: 157
  • Karma: 12
  • Location: Florence Alabama
Re: Nut/Bolt Torque
« Reply #2 on: September 05, 2016, 04:36:35 pm »
Yeah that the way I have done it for over 50 years. Never had one come loose ---but why take the chance when I have a 3/8 calibrated Armstrong wrench.
I have also replace a lot of crankshafts that were twisted off from over tightening and replaced a few coils and other items when they came loose!
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
22 Replies
2659 Views 		Last post September 20, 2014, 06:12:53 pm
by aclarke
9 Replies
495 Views 		Last post December 03, 2013, 10:21:18 am
by Cut4fun .
31 Replies
775 Views 		Last post November 17, 2013, 05:05:45 pm
by oldtimber
3 Replies
287 Views 		Last post October 18, 2014, 12:19:21 pm
by KilliansRedLeo
1 Replies
293 Views 		Last post October 23, 2014, 11:35:16 pm
by aclarke
4 Replies
403 Views 		Last post June 26, 2015, 10:22:07 pm
by jmester
1 Replies
218 Views 		Last post January 25, 2016, 11:21:00 am
by srcarr52
1 Replies
155 Views 		Last post February 12, 2016, 09:13:00 am
by fuzz1500
4 Replies
168 Views 		Last post February 06, 2019, 01:46:24 pm
by HolmenTree
1 Replies
143 Views 		Last post May 19, 2019, 07:45:02 am
by Cut4fun .