Author Topic: Where? Echo Specialty Tools and Service/ workshop manual  (Read 748 times)

0 Members and 0 Guests are viewing this topic.

Offline aclarke

  • Nitro Hotsaw
  • *******
  • Posts: 1676
  • Karma: 172
Good price on the set. Been told the Husky tool works on some Echo model drive gears but unconfirmed.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22074
  • Karma: 548
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
I got a poulan one for 330 380 3750 3450. It works on 1 of the 2 worm gears used on the jonsered 490 590 partner 500 5000 saws. Thinking the coarser one. Not sure.
REDNECK Saw Repair Getter Done

Offline sharkey

  • Piped Saw
  • *****
  • Posts: 367
  • Karma: 37
I use a plumbing nut to thread over the worm and then pull it with either a gear puller or if theyre really down in the case, I use a washer and a steering wheel puller.  Ive got some pics around here that I sent someone else who was having trouble getting one off.  I try to find them and post them for you.

Offline deereguy

  • 3 cube
  • *
  • Posts: 13
  • Karma: 1
Great idea!  I was thinking about something similar when I was doing the breakdown.  I went through my large nuts in the barn but found nothing that would do the job.     

I try never to hurry a breakdown.  If I'm stuck, I will put it aside and work on something else until I figure out how to do it.  Reminds me, getting the thick washer off in front of the oiler was tricky.  After a while, I discovered that the washer had treads in the holes (small hole not easily noticeable).   I could find ipls which were helpful but no service manuals.  I've been playing with saw for many years and don't have one Echo service manual.  rick


Related Topics

  Subject / Started by Replies Last post
1 Replies
Last post June 29, 2013, 12:46:13 pm
by RoyM
2 Replies
Last post December 18, 2013, 09:29:41 pm
by fossil
0 Replies
Last post October 24, 2020, 11:44:31 am
by Cut4fun .