Author Topic: Remove walbro carb screw limiters  (Read 2300 times)

0 Members and 0 Guests are viewing this topic.

Offline farmboy

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1170
  • Karma: 149
  • Location: Hayesville, NC
Re: Remove walbro carb screw limiters
« on: February 06, 2014, 09:27:34 am »
Take carb off trim tabs off with razor knife in place.  You won't need to remove them.  Walbro does make a tool for pulling them.  I have the tool but never use it. Tool has two little pins that go in the little round holes to locate tool and hooks under the stops to pull against the stops.  After trimming stops tool is rendered useless nothing to pull against.  Just did 3 of those carbs recently.  HDA160 IIRC.  CS56, 156, 962, 162, 165 use the same carb.
Shep

 

Related Topics

  Subject / Started by Replies Last post
10 Replies
992 Views
Last post November 10, 2017, 12:29:46 pm
by ray benson
19 Replies
2469 Views
Last post November 13, 2019, 10:54:28 am
by Cut4fun .
7 Replies
510 Views
Last post December 18, 2013, 12:25:10 pm
by KilliansRedLeo
15 Replies
281 Views
Last post February 20, 2014, 09:34:42 am
by KilliansRedLeo
10 Replies
192 Views
Last post April 30, 2014, 06:24:16 pm
by sharkey
3 Replies
484 Views
Last post October 06, 2015, 02:35:12 pm
by tassin85
17 Replies
193 Views
Last post October 30, 2015, 08:26:24 am
by 660magnum
7 Replies
361 Views
Last post February 03, 2016, 02:37:56 pm
by Cut4fun .
1 Replies
84 Views
Last post October 20, 2019, 10:02:38 am
by Cut4fun .
5 Replies
155 Views
Last post January 29, 2020, 02:39:53 pm
by ENTS