« previous next »
Pages: [1]   Go Down

Author Topic: Homelite C series / XP Cylinder Porting Question  (Read 848 times)

0 Members and 0 Guests are viewing this topic.

Offline sharkey

  • Piped Saw
  • *****
  • Posts: 367
  • Karma: 37
Re: Homelite C series / XP Cylinder Porting Question
« on: October 15, 2013, 12:25:35 am »
Did a little digging and it looks like there are similar models.  Ignitions and starters are different but carbs and top ends may mix and match. 
C-9, stroke 1.5625 in., bore 2.0625 in
xl-925, stroke 1.500 in, bore 2.0625 in.
C-51, stroke 1.5 in., bore    2.00 in.

Scott at Chainsawr might have a cylinder and piston set that would bolt right on. 
http://store.chainsawr.com/products/homelite-c-5-c-51-c-52-chainsaw-piston-and-cylinder-set
   
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
6 Replies
1656 Views 		Last post June 01, 2016, 09:03:45 pm
by RobbinW
2 Replies
564 Views 		Last post March 02, 2012, 09:54:14 am
by 2spud
0 Replies
360 Views 		Last post August 02, 2012, 08:25:19 am
by Hal
9 Replies
1501 Views 		Last post November 17, 2012, 09:05:18 pm
by Mw1995
6 Replies
890 Views 		Last post September 13, 2013, 12:49:19 pm
by 3000 FPS
5 Replies
421 Views 		Last post November 01, 2013, 11:30:50 pm
by 660magnum
8 Replies
654 Views 		Last post October 14, 2014, 07:17:32 am
by Trang77
1 Replies
177 Views 		Last post November 05, 2017, 03:25:43 pm
by ray benson
5 Replies
163 Views 		Last post May 10, 2016, 09:45:37 pm
by huskyslinger
0 Replies
165 Views 		Last post December 22, 2022, 07:56:33 am
by Cut4fun