« previous next »
Pages: [1]   Go Down

Author Topic: Super EZ flooding  (Read 841 times)

0 Members and 13 Guests are viewing this topic.

Offline fossil

  • 6 cube
  • ****
  • Posts: 205
  • Karma: 66
  • Location: Brampton, Ontario

    • Total Badges: 28
    Badges: (View All)
    Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary
Re: Super EZ flooding
« on: July 13, 2016, 10:49:52 am »
These saws are not the easiest to tune.

Start with 1 turn out on high and 3/4 turn out on low and tune from there. As long as you're four stroking at wide open at no load and it cleans up in the cut don't worry where the mix screws are.
Those settings are what's recommended in the repair manual.
Make sure your adjustments are made in tiny increments at around 1/16 turn.

Low side, as always, tune so it rev's up smoothly from idle but not too rich.
Logged
Tim
Like Like x 1 View List
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
Super bee

Started by Al Smith Stihl

2 Replies
716 Views 		Last post May 12, 2011, 04:40:04 am
by Al Smith
4 Replies
1501 Views 		Last post March 31, 2012, 07:41:36 pm
by Al Smith
35 Replies
3681 Views 		Last post March 24, 2013, 08:12:44 am
by Al Smith
5 Replies
1037 Views 		Last post February 13, 2013, 09:19:15 am
by bawtwblud
Husqvarna 372 flooding

Started by Cory « 1 2 ... 7 8 » Husqvarna

70 Replies
4588 Views 		Last post March 18, 2015, 10:06:24 am
by srcarr52
3 Replies
521 Views 		Last post August 29, 2013, 10:20:40 am
by Adirondackstihl
6 Replies
419 Views 		Last post November 23, 2015, 11:19:43 am
by Fish
6 Replies
441 Views 		Last post November 17, 2017, 01:39:57 am
by Revpop
12 Replies
696 Views 		Last post October 22, 2021, 12:06:37 pm
by pmeyers
3 Replies
291 Views 		Last post April 22, 2023, 10:56:40 am
by Cut4fun .