Author Topic: Husqvarna 2100 2101 1100 298  (Read 6865 times)

0 Members and 95 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23708
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: 2100 no power in the cut
« Reply #30 on: July 30, 2014, 07:11:53 pm »
I just spent 2hrs with this 2100. First tested and seen what owner was talking about. Start making cut and it would shut off. Tried it a couple times same thing.

Took it to the bench and pulled carb and tore it down checking things. I adjusted the fulcrum and the needle look new so put it back.  You replaced the needle right? Diaphragms looked good on both sides, so no use opening that new kit IMO.  The choke wasnt closing all the way but that is another story. Fixed.

Checked spark with the new tool and even after stops and testing it showed. GREEN (flashing) Proper voltage, ingnition is OK

I made  4 full cuts in 17.5" dry maple no problems and starting on 5th cut when raised up out of wood to hit 5th cookie she went into a run on like on the race saws. I hit the kill switch and it did nothing. So I then took my hand and pushed into the green weenie filter to block off air to shut her down.

While still hot I started trying to start and check things and it was just erratic with it's idle and starting when hot.

I am thinking there are bigger issues here from a  air leak once warmed up.  What do you all think, seals, base,  etc?

I dont know 2100's so hoping you all can shed some light. 
 

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
775 Views
Last post July 31, 2011, 12:00:53 pm
by Cut4fun .
3 Replies
603 Views
Last post October 30, 2012, 07:54:20 pm
by Cut4fun
Husqvarna 2100

Started by turbo885 « 1 2 3 4 5 » Husqvarna

46 Replies
2248 Views
Last post February 03, 2014, 05:04:02 pm
by Eccentric
11 Replies
1723 Views
Last post October 06, 2013, 10:12:00 pm
by stihls066
5 Replies
558 Views
Last post October 05, 2013, 01:44:26 am
by Eccentric
10 Replies
1026 Views
Last post August 15, 2014, 06:03:50 am
by man of stihl
5 Replies
360 Views
Last post November 14, 2014, 10:04:03 am
by bloodontheice
12 Replies
1154 Views
Last post May 13, 2015, 06:41:55 pm
by SquareFile
0 Replies
271 Views
Last post May 23, 2018, 07:34:41 am
by Cut4fun .
1 Replies
336 Views
Last post May 24, 2018, 02:27:47 pm
by Cut4fun .