Author Topic: 357 xpg starting and running problem  (Read 117 times)

0 Members and 0 Guests are viewing this topic.

Offline FinnishWoodsman

  • pruner
  • *
  • Posts: 1
  • Karma: 0
357 xpg starting and running problem
« on: October 16, 2019, 02:57:23 pm »
So, my 357 xpg starts very roughly. I have to pull many times and use the choke eventhough the engine is hot already. While holding the throttle everything seems normal, but when laying the saw down to idle it cuts out.
What could cause this?

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21948
  • Karma: 533
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: 357 xpg starting and running problem
« Reply #1 on: October 17, 2019, 12:37:20 pm »
Check and see if your 357 has the auto decompression.   IMO if so remove it and plug the hole and put reular decomp in the other side of cylinder.
This was what was done to one of mine years back.

Also check to see if you have the old plastic intake clamp and partion.  The plastic ones known to warp and create a air leak. Will burn yor saw up.

3rd Have you rebuilt your carb lately?  Some kits not right for the HDA199 etc.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
975 Views
Last post July 04, 2012, 05:29:50 pm
by SawTroll
ms361 not starting

Started by haasper « 1 2 3 » Stihl

22 Replies
1713 Views
Last post December 28, 2012, 04:42:43 pm
by 660magnum
3 Replies
217 Views
Last post February 20, 2013, 04:39:47 pm
by Cut4fun .
21 Replies
435 Views
Last post July 27, 2014, 06:12:27 pm
by JohnG28
2 Replies
233 Views
Last post July 06, 2014, 08:25:56 am
by bardos
0 Replies
93 Views
Last post June 20, 2015, 12:02:22 pm
by Cut4fun .
6 Replies
705 Views
Last post December 23, 2016, 04:52:43 am
by DNX800
8 Replies
490 Views
Last post August 12, 2017, 02:45:56 pm
by 660magnum
6 Replies
209 Views
Last post August 28, 2017, 01:01:34 am
by tfox1994
0 Replies
94 Views
Last post August 23, 2018, 07:47:32 pm
by John Mc