Author Topic: 2100 piston husqvarna  (Read 1217 times)

0 Members and 0 Guests are viewing this topic.

Offline Nathaniel Vansickle

  • Piped Saw
  • *****
  • Posts: 468
  • Karma: 92
  • Location: Newcomerstown ,Ohio
Re: 2100 piston
« on: February 24, 2015, 10:24:47 am »
first couple dozen i used i have no idea. I never checked. Again i wasnt all that well informed and was jsut learning. Last couple years i havent used near as many( switched to meteor) but they have all been in spec as best as you can measure with calipers. wrist pin has always slid right through with no binding and circle clip grooves have always been nice. They are not OEM or meteor quality but i would never hesitate to use them in a stock saw. Worst offense that i have found is leftover casting flash on an edge here and there that needs buffed off. Northwood carries them but doesnt label them as VEC in the descriptions. they are labeled as high quality import and usually around $29. Which since the first of the year makes them less appealing since Stihl lowered their prices and Chris started carrying Meteor at great prices.

I have also used Mako pistons which arent bad looking for the money but the circle clip grooves are horrible.
Raisman Platt are horrible too. used 2 of them and both had the ring locating pin drilled all the way through the piston. i called and they said it was normal and they would warranty if a problem came up so i used it. still going strong but i wont use another.
5105H and 6400H in stock

Performance Outdoor Equipment
Dolmar, Echo, Jonsered

Like Like x 1 View List


Related Topics

  Subject / Started by Replies Last post
1 Replies
Last post July 06, 2011, 06:25:52 am
by Al Smith
Husqvarna 2100

Started by darren_palms « 1 2 ... 6 7 » Husqvarna

63 Replies
Last post April 25, 2015, 10:21:41 am
by Cut4fun .
0 Replies
Last post January 18, 2013, 10:20:59 pm
by darren_palms
Husqvarna 2100

Started by turbo885 « 1 2 3 4 5 » Husqvarna

46 Replies
Last post February 03, 2014, 05:04:02 pm
by Eccentric
151 Replies
Last post October 23, 2019, 01:38:04 pm
by raumato01
13 Replies
Last post May 15, 2015, 05:37:49 pm
by EHP
9 Replies
Last post February 12, 2016, 06:47:54 pm
by 604f_1
0 Replies
Last post October 26, 2016, 02:37:29 pm
by Cut4fun
1 Replies
Last post December 06, 2016, 11:35:26 am
by Cut4fun .
3 Replies
Last post April 27, 2017, 12:58:18 am
by mdavlee .