Author Topic: 272 cylinder on a 254?  (Read 599 times)

0 Members and 4 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna
Re: 272 cylinder on a 254?
« on: February 24, 2014, 03:03:06 pm »
At the risk of being wrong three times in this thread; the 254 and the 272 both have a stroke of 34mm. That being said, we have to take into account what Troll said about same stroke but different length connecting rod. I have not been able to find the difference in length of the 254XP and 272XP connecting rods.

However, here is my supposition the differing length rods will most likely throw the port timing of the saw off.
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
211 Views
Last post February 13, 2016, 11:05:35 am
by sharkey
2 Replies
382 Views
Last post November 07, 2016, 05:17:35 pm
by oldpro
4 Replies
205 Views
Last post November 06, 2016, 10:35:55 am
by SawTroll
3 Replies
479 Views
Last post November 21, 2016, 02:29:41 pm
by Cut4fun .
1 Replies
432 Views
Last post November 22, 2016, 05:54:51 pm
by Cut4fun .
7 Replies
438 Views
Last post August 25, 2017, 06:40:44 am
by jmester
10 Replies
596 Views
Last post August 22, 2018, 07:58:11 am
by pete
5 Replies
319 Views
Last post November 19, 2019, 11:03:09 am
by Cut4fun .
0 Replies
91 Views
Last post February 17, 2020, 07:27:15 am
by Cut4fun
4 Replies
302 Views
Last post February 29, 2020, 07:34:27 am
by Cut4fun .