Author Topic: 335XPT California Vs 338XPT  (Read 621 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: 335XPT California Vs 338XPT
« on: December 30, 2013, 02:52:17 pm »
Thanks for the info Kevin.  Taking on that little bugger will probably be an exercise in frustration..............but I'm tempted for some reason.  It's a handy feeling little stinker, and is in such good shape (on the outside anyways)...

I've pulled some IPL's from the Husqvarna site as well.  Lots of changed part #'s.   One thing that I found interesting is  that the saw in question has the oval foam air filter setup (as seen in some earlier non-CA 335XPT IPL's).  All of the CA IPL's that I've seen so far show the later pleated paper/plastic filter.  This saw clearly has the "338XPT California" badging on the starter cover.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
37 Replies
959 Views
Last post March 08, 2014, 03:15:48 pm
by SawTroll
8 Replies
414 Views
Last post January 04, 2014, 04:42:43 pm
by Cut4fun .
4 Replies
253 Views
Last post November 23, 2014, 03:36:23 pm
by Cut4fun .
2 Replies
281 Views
Last post May 15, 2016, 04:59:09 am
by Eccentric
7 Replies
283 Views
Last post May 15, 2016, 04:49:22 am
by Eccentric
10 Replies
461 Views
Last post June 21, 2016, 03:18:11 pm
by Giles
2 Replies
279 Views
Last post December 26, 2016, 05:32:01 pm
by SawTroll