Author Topic: Husqvarna 338XPT  (Read 6907 times)

0 Members and 50 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23708
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: 338 XPT Husqvarna
« Reply #20 on: January 19, 2013, 10:46:20 am »
Wow RB says there is BIG gains to be had on this saws.  RB did  a Jonsered 2139 = 338

Is this the mod done on your 338 Willard?

Quote
I run mine with a 9/16th ID tube. The best place to add it is about an inch below the existing tiny port, and angled downward at 30 degrees or so. A hole will need to be formed in the plastic cover. Make the tube the proper length so that it ends just short of the plane of the cover, to eliminate being burned. Retune carb, and be prepared to cut 25-40% faster than stock.



 

Related Topics

  Subject / Started by Replies Last post
2 Replies
648 Views
Last post March 04, 2012, 02:35:58 pm
by Cut4fun .
7 Replies
1093 Views
Last post January 31, 2016, 12:49:24 pm
by 660magnum
0 Replies
342 Views
Last post March 30, 2016, 07:10:38 pm
by mikehonda
4 Replies
664 Views
Last post April 12, 2016, 06:30:34 pm
by dannyupsolate
4 Replies
735 Views
Last post November 07, 2016, 05:46:56 pm
by oldpro
2 Replies
702 Views
Last post May 15, 2016, 04:59:09 am
by Eccentric
20 Replies
2476 Views
Last post March 21, 2018, 10:47:30 am
by Cut4fun .
4 Replies
681 Views
Last post November 23, 2016, 02:23:26 am
by georgehopson
1 Replies
461 Views
Last post October 26, 2016, 03:40:28 pm
by Eccentric
0 Replies
601 Views
Last post January 16, 2017, 03:40:49 pm
by HolmenTree