« previous next »
Pages: [1] 2 3 4   Go Down

Author Topic: 359/357xp  (Read 1838 times)

0 Members and 53 Guests are viewing this topic.

Offline Bluegill

  • 5 cube
  • ***
  • Posts: 141
  • Karma: 22

    • Total Badges: 21
    Badges: (View All)
    Level 5 Third year Anniversary Second year Anniversary Avatar Topic Starter Level 4
Re: 359/357xp
« on: December 02, 2014, 07:57:33 pm »
Quote
Is the 359 top end a direct bolt on to a 357? I think i was reading one time the small end of the rod on a 359 was different than the 357??? I'm thinking about taking the ported cylinder off my 357,find a stock OEM 357 or 359 top end for it and sell it. I don't race it anymore due to my Danny Henry 365 being faster.

If I remember right the early 357s' had a smaller 'small rod end'. Later ones, both models are the same. Not sure though... The 2 359s' I have both interchange with the 357xp.
Logged
Pages: [1] 2 3 4   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
Husqvarna 357xp

Started by Cut4fun « 1 2 3 4 » Husqvarna

38 Replies
4395 Views 		Last post October 30, 2013, 01:19:57 pm
by Cut4fun
7 Replies
1152 Views 		Last post July 24, 2012, 03:35:33 pm
by Cut4fun .
45 Replies
3470 Views 		Last post November 18, 2012, 11:18:43 am
by fatboycowen
5 Replies
819 Views 		Last post January 12, 2013, 10:18:19 pm
by HolmenTree
7 Replies
581 Views 		Last post February 06, 2015, 12:30:00 pm
by Cut4fun .
2 Replies
298 Views 		Last post July 15, 2016, 05:47:37 pm
by Acel83
21 Replies
1268 Views 		Last post December 17, 2016, 11:24:32 am
by wild262
8 Replies
837 Views 		Last post August 24, 2018, 08:53:00 am
by Cut4fun .
6 Replies
485 Views 		Last post January 05, 2020, 12:14:41 am
by Derf
10 Replies
913 Views 		Last post September 23, 2020, 09:52:06 pm
by Spike60