Chainsaw Repair

Quote from: SawTroll on June 08, 2012, 10:11:08 pm

Quote from: Cut4fun on June 06, 2012, 05:41:44 pm

.......

I checked flywheel, coil gap and tightness of both. I knew it had a brand new hardly used NGK BPMR4A in it after complete rebuild with new crank etc so I left it in.  I then pulled zama carb and went through it, I couldnt see anything wrong. I pulled a walbro off the shelf and put a kit in it. Installed walbro and had same issue. So that ruled out carb in my pea brain.   ......

This is a bit odd, as a 362xp shouldn't have come with a Zama carb, only the early 365s? 

Niko did you read the thread on the build of this 362xp?     It was built piece by piece. Split bare crankcases to start, bought new oem crank and tank, etc, etc. I put the zama carb on it because that is what I had.