Author Topic: Husqvarna 362xp  (Read 5466 times)

0 Members and 30 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23708
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: 362xp
« Reply #30 on: June 07, 2012, 09:13:14 am »
While looking at saw after carb switch and testing. I decided to remove the like new NGK plug and look at the exhaust side bore etc. When putting it back  I put a Bosch WS5E in. Fired up and ran fine with walbro I just put on it too. So Now the zama can go back on.

Turns out it was the NGK plug had went bad. It would restart and all.  It would run under load and WOT. It just wouldnt idle, it would pop once and dead shut off. 


 

Related Topics

  Subject / Started by Replies Last post
2 Replies
648 Views
Last post March 04, 2012, 02:35:58 pm
by Cut4fun .
12 Replies
1235 Views
Last post February 11, 2013, 04:22:19 pm
by Cut4fun
25 Replies
5527 Views
Last post February 03, 2013, 01:45:30 pm
by Cut4fun .
3 Replies
924 Views
Last post July 24, 2012, 09:40:25 pm
by 660magnum
5 Replies
362 Views
Last post December 14, 2013, 01:27:33 pm
by J.Walker
8 Replies
642 Views
Last post December 28, 2013, 09:34:45 am
by SawTroll
55 Replies
2086 Views
Last post June 10, 2014, 10:30:43 am
by KilliansRedLeo
4 Replies
574 Views
Last post July 12, 2014, 05:55:01 pm
by KilliansRedLeo
2 Replies
231 Views
Last post June 27, 2015, 10:09:07 pm
by Jason K
15 Replies
1034 Views
Last post September 07, 2015, 06:40:03 pm
by Cut4fun .