Author Topic: 371 issues.  (Read 1723 times)

0 Members and 4 Guests are viewing this topic.

Offline cowroy

  • 4 cube
  • **
  • Posts: 62
  • Karma: 2

  • Total Badges: 17
    Badges: (View All)
    Level 4 Karma One year Anniversary Search Linux User 50 Posts
Re: 371 issues.
« Reply #20 on: July 24, 2013, 01:49:54 pm »
Well, I'll have to check and see. What I did was put my ported 371 top end on a 365sp bottom end because the 365 was a very low hour saw. My 371 bottom end ran fine, but since I had the low hour one I went with it. I also decided to switch the carbs because the venturi on the 371 carb was noticeably smaller, so I will have to have a look at the the carb that I swapped out to see what the number was.

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
467 Views
Last post July 30, 2014, 10:21:15 pm
by aclarke
17 Replies
2176 Views
Last post September 15, 2014, 12:30:02 pm
by 660magnum
5 Replies
853 Views
Last post June 21, 2015, 12:59:48 pm
by Cut4fun .
4 Replies
512 Views
Last post November 30, 2015, 08:11:00 pm
by 3000 FPS
11 Replies
775 Views
Last post December 07, 2015, 09:34:54 am
by weimedog
4 Replies
380 Views
Last post February 09, 2016, 12:40:49 pm
by Cut4fun .
21 Replies
1181 Views
Last post December 06, 2016, 03:13:16 pm
by Cut4fun .
6 Replies
1726 Views
Last post December 23, 2016, 04:52:43 am
by DNX800
3 Replies
469 Views
Last post September 07, 2017, 04:49:31 pm
by Goofy3392
1 Replies
312 Views
Last post March 20, 2021, 07:21:13 am
by Cut4fun