« previous next »
Pages: 1 2 3 [4] 5   Go Down

Author Topic: 371 issues.  (Read 1762 times)

0 Members and 20 Guests are viewing this topic.

Offline dozerdan

  • 4 cube
  • **
  • Posts: 25
  • Karma: 3

    • Total Badges: 19
    Badges: (View All)
    Third year Anniversary Avatar Signature Level 4 Quick Poster Karma Good
Re: 371 issues.
« Reply #30 on: July 24, 2013, 08:33:36 pm »
Quote from: Cut4fun on July 24, 2013, 01:58:08 pm
Little something I found on the zama 362 365 carbs.  I ran them on 372 too.

Zama carb has smaller venturi  too. But on a work saw I never noticed a difference in them in the cut on a stock, muffler modded, woods ported work saw.  If I hadnt told you it was running a zama you would have never known the difference.

I think dozerdan had done the same testing on woods ported work saws between zama and walbro HD12.   

On a woods ported 372 saw there really isn't any noticeable difference between the Zama that was on the 365s and the Walbo HD12. I am sure that if you timed the cuts that the Walbro will have a very slight edge. You will never feel that edge cutting firewood.

Later
Dan
Logged
Danny Henry
dozerdan@sunlink.net
570 658 6232
Pages: 1 2 3 [4] 5   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
474 Views 		Last post July 30, 2014, 10:21:15 pm
by aclarke
17 Replies
2234 Views 		Last post September 15, 2014, 12:30:02 pm
by 660magnum
5 Replies
874 Views 		Last post June 21, 2015, 12:59:48 pm
by Cut4fun .
4 Replies
519 Views 		Last post November 30, 2015, 08:11:00 pm
by 3000 FPS
11 Replies
786 Views 		Last post December 07, 2015, 09:34:54 am
by weimedog
4 Replies
389 Views 		Last post February 09, 2016, 12:40:49 pm
by Cut4fun .
21 Replies
1209 Views 		Last post December 06, 2016, 03:13:16 pm
by Cut4fun .
6 Replies
1755 Views 		Last post December 23, 2016, 04:52:43 am
by DNX800
3 Replies
476 Views 		Last post September 07, 2017, 04:49:31 pm
by Goofy3392
1 Replies
312 Views 		Last post March 20, 2021, 07:21:13 am
by Cut4fun