Author Topic: 371xp not running  (Read 2913 times)

0 Members and 48 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna

  • Total Badges: 29
    Badges: (View All)
    2000 post CR Staff One year Anniversary 1000 Posts Never Sleep Group
Re: 371xp not running
« Reply #40 on: February 21, 2014, 09:35:38 am »
Saw arrived for repair yesterday. I will post some pictures of the C/P later in the day. Rings welded in the grooves, very large aluminum deposits below and above the EP on the right side. There are a couple of fins broken off the cylinder right where she stuck. So, I am wondering what if anything that this had to do with it.

Clutch side seal is shot, before disassembly I tried to put pressure in the saw and could not get it to hold any pressure at all, not even a pound.

Something fell on the saw at one time or it was dropped as the clutch side of the case has a crack at the right rear of the carb box and the case ear where the travel limiter would be located is completely gone.

I will post pictures of that also. I am wondering if hearing the case to remove and replace the bearings will cause further damage to the case.
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
639 Views
Last post November 18, 2012, 10:50:17 am
by Cut4fun .
5 Replies
1030 Views
Last post January 02, 2013, 08:23:58 am
by William Greene
6 Replies
2062 Views
Last post June 02, 2013, 09:30:02 pm
by brokenbudget
28 Replies
1458 Views
Last post August 11, 2013, 03:46:32 pm
by brokenbudget
5 Replies
607 Views
Last post October 03, 2013, 11:51:34 am
by 660magnum
8 Replies
1366 Views
Last post November 12, 2013, 08:11:36 pm
by Cut4fun .
17 Replies
2620 Views
Last post November 25, 2013, 01:09:47 pm
by crankincraig
2 Replies
671 Views
Last post April 23, 2014, 06:31:10 pm
by Jason K
16 Replies
984 Views
Last post May 02, 2014, 09:50:35 am
by KilliansRedLeo
4 Replies
459 Views
Last post June 20, 2014, 09:24:30 am
by Fish