« previous next »
Pages: 1 [2]   Go Down

Author Topic: 390xp info  (Read 1562 times)

0 Members and 0 Guests are viewing this topic.

Offline mdavlee .

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1968
  • Karma: 171
Re: 390xp info
« Reply #10 on: January 21, 2015, 04:58:42 pm »
Quote from: Reddog on January 21, 2015, 09:08:06 am
Bump an old thread with a 390xp question.

I have noticed this saw pulls down into mid range rpm but has a load of torque there. So I just use a 8pin to get the chain speed up.

Question is will a muffler mod raise the peak torque curve or just make it louder with little gain in rpm while in the cut?
You running a 20" or 24" bar?
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
49 Replies
16300 Views 		Last post February 13, 2016, 06:19:32 pm
by farmboy
39 Replies
2765 Views 		Last post August 25, 2014, 07:35:19 am
by KilliansRedLeo
40 Replies
1748 Views 		Last post December 20, 2013, 01:00:22 pm
by Spike60
6 Replies
559 Views 		Last post November 07, 2014, 08:44:37 pm
by farmboy
5 Replies
217 Views 		Last post February 08, 2015, 06:59:41 pm
by Cut4fun .
2 Replies
676 Views 		Last post August 22, 2015, 10:26:29 am
by 1manband
0 Replies
326 Views 		Last post March 17, 2016, 12:54:13 pm
by Cut4fun .
0 Replies
248 Views 		Last post March 30, 2016, 07:10:38 pm
by mikehonda
4 Replies
548 Views 		Last post August 13, 2017, 01:48:48 pm
by Cut4fun .
0 Replies
370 Views 		Last post September 17, 2017, 10:30:11 am
by Cut4fun .