Author Topic: 44mm husqvarna 350 upgrade options .  (Read 2423 times)

0 Members and 25 Guests are viewing this topic.

Offline fuzz1500

  • 4 cube
  • **
  • Posts: 35
  • Karma: 5

  • Total Badges: 18
    Badges: (View All)
    Second year Anniversary Linux User Level 4 10 Posts Karma Topic Starter
Re: 44mm husqvarna 350 upgrade options .
« on: January 26, 2016, 07:41:36 pm »
Hi guys !  Looking for advice on my 350 build.  Outing the riser back on.  I flat sanded the base....put the three bond on.  ..installed it.....then wondered if I should have sealed around the bearing seal grooves on the riser..and in the plastic case.  The seals fit sooooo tight into the grooves...I honestly didn't wanna hurt anything by adding sealant into the mix.  It seemed to seal nice and tight..so idk.  What have you guys done in the past ?

 

Related Topics

  Subject / Started by Replies Last post
103 Replies
5355 Views
Last post February 24, 2014, 05:49:35 am
by 350XP
0 Replies
1618 Views
Last post April 04, 2012, 12:29:54 pm
by Cut4fun
11 Replies
1645 Views
Last post May 18, 2012, 10:03:11 pm
by Al Smith
8 Replies
1339 Views
Last post April 16, 2014, 07:38:59 am
by farmboy
4 Replies
499 Views
Last post December 06, 2013, 01:29:38 am
by AKDoug
51 Replies
2949 Views
Last post September 12, 2014, 07:41:52 am
by 660magnum
8 Replies
904 Views
Last post September 07, 2014, 10:24:52 am
by 660magnum
41 Replies
3415 Views
Last post May 08, 2015, 12:14:40 pm
by aclarke
ms250 oiler upgrade

Started by Mark T « 1 2 » Stihl

11 Replies
1952 Views
Last post April 19, 2015, 09:17:13 pm
by 660magnum
0 Replies
332 Views
Last post August 19, 2021, 08:32:36 am
by Cut4fun .