« previous next »
Pages: 1 [2]   Go Down

Author Topic: 44mm husqvarna 350 upgrade options .  (Read 2472 times)

0 Members and 22 Guests are viewing this topic.

Offline wild262

  • 6 cube
  • ****
  • Posts: 161
  • Karma: 29

    • Total Badges: 14
    Badges: (View All)
    Third year Anniversary Second year Anniversary 100 Posts Level 3 One year Anniversary 50 Posts
Re: 44mm husqvarna 350 upgrade options .
« Reply #10 on: January 26, 2016, 09:22:50 pm »
If I were you I would do it over just to be sure.  I coat everything when I do one of those.  Thin coat on both surfaces after degreasing with alcohol.  Better safe than sorry.   And use some lock-tight on those bottom riser bolts also especially the course thread ones.   Afterward, let it cure out at least 1 day before starting.  Weimiedog has built a lot of these and maybe he can come in and take over where I left off.  Good wrenching partner! :)
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
103 Replies
5381 Views 		Last post February 24, 2014, 05:49:35 am
by 350XP
0 Replies
1625 Views 		Last post April 04, 2012, 12:29:54 pm
by Cut4fun
11 Replies
1648 Views 		Last post May 18, 2012, 10:03:11 pm
by Al Smith
8 Replies
1346 Views 		Last post April 16, 2014, 07:38:59 am
by farmboy
4 Replies
500 Views 		Last post December 06, 2013, 01:29:38 am
by AKDoug
51 Replies
2980 Views 		Last post September 12, 2014, 07:41:52 am
by 660magnum
8 Replies
907 Views 		Last post September 07, 2014, 10:24:52 am
by 660magnum
41 Replies
3466 Views 		Last post May 08, 2015, 12:14:40 pm
by aclarke
ms250 oiler upgrade

Started by Mark T « 1 2 » Stihl

11 Replies
1983 Views 		Last post April 19, 2015, 09:17:13 pm
by 660magnum
0 Replies
332 Views 		Last post August 19, 2021, 08:32:36 am
by Cut4fun .