Author Topic: 455 starts then dies  (Read 466 times)

0 Members and 54 Guests are viewing this topic.

Offline Beeto

  • pruner
  • *
  • Posts: 1
  • Karma: 0

  • Total Badges: 3
    Badges: (View All)
    Level 1 Search Windows User
455 starts then dies
« on: March 31, 2022, 12:15:16 pm »
455 starts right up then dies after a few seconds.  I have installed: new carburetor, new fuel filter, new air filter, new fuel lines, new primer bulb, and cleaned: the impulse line as best I could, the spark arrestor, the fuel breather.  I removed the intake manifold and didn't see any cracks or splits, and checked compression, swapped out a coil that I know was working on another 455.

It will not stay running long enough to make any carb adjustments. 

I have owned the saw for 20 years but I'm not a heavy user- used it very sparingly around the farm.

What am I missing?     

Thanks!

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23708
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: 455 starts then dies
« Reply #1 on: April 01, 2022, 07:50:25 am »
New carb aftermarket?   They can be hit or miss. 
Carb adjustment setting from get go close to be able to start and run (not all carbs and saws the same)?
Check for impulse blockage. 
Has impulse line been replaced?     
Crank seals etc checked?
Vac and pressure test?
Has piston ring in a blind corner been pinned. Seen that before too.

I hate these style of strato saws with the dang tubes. Just air leaks waiting to happen. Poor design. IMO.



 

 

Related Topics

  Subject / Started by Replies Last post
13 Replies
1658 Views
Last post March 09, 2012, 01:51:34 pm
by eli-dream
17 Replies
2032 Views
Last post February 12, 2013, 07:48:58 am
by bassman
9 Replies
1481 Views
Last post October 26, 2013, 10:25:33 pm
by 660magnum
21 Replies
1673 Views
Last post April 11, 2014, 08:58:12 pm
by 3000 FPS
16 Replies
1158 Views
Last post December 27, 2013, 05:37:28 am
by 660magnum
7 Replies
1004 Views
Last post October 29, 2014, 03:58:59 pm
by Fish
16 Replies
1786 Views
Last post October 25, 2015, 09:19:53 pm
by mikehonda
4 Replies
526 Views
Last post March 30, 2018, 10:35:37 am
by joel4bs
2 Replies
770 Views
Last post July 04, 2018, 08:14:36 am
by Cut4fun .
3 Replies
417 Views
Last post September 12, 2018, 03:41:52 pm
by bsaumph